Search Results for ‘alignment’

I have a 2007 RRSC with the Johnson Rod 2 inch lift rods. Does anyone recommend going to a specialty offroad shop for alignment or will a national shop be able to align with no problem? does the national shop just use the parameters from manufacturer, which I guess would be at normal ride height?

Hello Range family, I have an '06 Land Rover Range Rover Sport Supercharged with about 180k on the dash. I have new tires and went to get an alignment because of the back end is moving WAY TO MUCH when I hit a simple hole. The alignment guy said he didn't think an alignment was needed but...

Hi does anyone know if you have to get the car into service mode to do this or can any garage do this without the LR computer set up? It seems the rear wheels on mine are OK but the front need attention. A tyre supplier / fitter has said this but they are not land Rover main dealers. Grateful if...

When replacing an air strut on a 2008 L322, is an alignment necessary? One shop never did one, the other swears it's a must. To me, you're not knocking anything out of alignment with the process but I could be wrong.

Here is the video of the sound the car is making at low speeds https://youtu.be/441tBfKQgGA This is all after 4 brand new Michelin tires and an alignment performed and installed at a Land Rover dealership. What could be causing this?

Greeting Everyone! 2004 Range Rover HSE Some days I get a bumpy ride like when it is cold and but some days it is not. I was wondering if the rotors/brakes to be the problem. It appears that eh wheel balancing should not be the issue as it would be out all the time right? I was goingt o...

Hi all, new to the forum. I purchased a roof rail kit for my RR and the kit does not have the plastic alignment parts (item Q in the instruction manual). Anyone out there still have them from fitting the rails to their vehicle? Thanks in advance.

I have a 2011 l322 sc, has anyone figured out/ solved the rear tire wear problem? Alignment specs for the rear are -1.5 degrees camber, that seems excessive. Has anyone tried aligning it to 0 degrees camber on the rear wheels and 0 toe? Thinking of trying it but thought someone may have been...

Very weird issue I've had with my 14. One side of the hood sits flush with the headlights and fender while the other has a small but noticeable gap in between. Can't stop noticing once I saw it. https://imgur.com/a/CL8JG Anyone have any advice or similar issue? And yes I've checked that...

Hi guys, Wondering if the fuel door can be adjusted, if anyone noticed this before, my fuel door is not centered and is almost rubbing against the body on one side, not sure maybe all the RRS come like that or maybe mine was just off centered from factory Sent from my iPhone using Tapatalk

Does anybody have a diagram or picture of how the oil pump / fuel pump chain aligns? I found pics for timing chains but not the oil chain. Many thanks in advance, Alan.

Hi I've recently purchased black leather 2012 interior after installing door cards and rear seat I've stumbled across front seat runners are different size and electrical connectors are different. Has anyone had success with this upgrade? I'd be most grateful for any info.

So today I decided my car needed a wheel balance because when the dealership a couple weeks back rotated my tires there was some steering wheel judder at high speeds. Everytime i went to the dealership it was late and my service advisor usually needs two weeks before he can work on my car...

I just purchased a used 2011 L322 that has truly been taken care of. As with any used car there are always a few little things that need to be fixed. I have searched the forum but am unable to find the answers to the following two questions: 1: My top glovebox door gets stuck on the bottom...

H guys, Iv'e been searching for a couple of hours through a myriad of old posts but can't find the factory wheel alignment specs for early L322. Last week I had an alignment done and my castor appears off. I had a look around google tonight and it seems there is an adjustable camber bolt...

I have a RRS 2012, and get a fair bit of wheel wobble when I reach 70 mph, the maximum speed on my local motorway...cough.... and I have a few questions. I assume it could be to do with the tracking or alignment, so can I take her to a local STS Tyre Pro to sort or do I need to go to a main...

I was helping a friend set up his race car a few months ago and got to experience his 3 laser chassis/alignment tool. Its basically a modern version of the string line you see racers use. Here is a pic of it in action (not my pic, a stock pic). Anyways, I called the manufacturer and asked if...

Hey all, the title pretty much says it all. I know several are running this set up, just want to see what the suggestions are out there for the best way to get it aligned, I finally got some miles on my set up and I am getting a wobble in the steering wheel from about 50-60mph. I have been...

After replacing the balljoints on my P38 the new oilseal started leaking: the hub is not aligned anymore (to low). Does anyone has a good alternative for the LRT-54-006 special tool? That one is way to expensive... Do I need to replace the taper collet nut on the bottom of the hub? Or can it be...

Firstly, I have nothing but good things to say about Arnot products. Here is the background. 3 years ago, I had a leak from the front bags, replaced with Arnott units. Approxamatly a year later I needed tires as the front was showing chord on the insides. I had an alignment done at the same...