Search Results for ‘46l’

Hey guys, New to the forum and to Land Rovers. I picked up a 1999 P38 that needed head gaskets and a starter. I completed the starter replacement first, and after I finished the job it cranked just fine. Then went ahead with the head gasket replacement, put everything back together and now I...

After laying down a high bid on BAT for the Unicorn, I had settled that this was fair if the vehicle was truly a 2k mileage P38 with no major issues. That said, this board and the maintenance challenges of this model had raised legitimate concerns that I might have gotten a bit over my skiis...

So here is my dilemma. I have a 2001 RR 4.6L SE, I just replaced the upper and lower ball joints. It only happens when I make right hand turns but the drivers side front tire seems to bind up. It feels like a coil spring is twisting and about to pop. It does slow the vehicle down quickly to a...

Hi guys a few month ago I bought my RR with only 100k miles from its original owner. I love it btw. It was a leisure vehicle before but I drive it daily in a mountainous environment and it’s awesome. Lately though when I accelerate from a stop or up a hill I’m hearing and feeling a clunking...

What do I need to swap a gems 4.6L into a 1994 Range Rover LWB. Other than what I think is obvious. Oil pan, intake manifold, plenum, exhaust manifolds and front timing cover. Thanks. Anyone have a good write up.

I just got the oil pan back on, filled it with oil, and this thing sounds weird. Definately something rotating badly. I'm going to pull the belt just to be sure though. What's your opinion. Youtube might still be turning the video. sorry for it being sideways.

For the past several years I have been the happy owner of a 2001 4.6L HSE. But it is getting up there in miles, and is a bit scruffy paint and interior wise. I bought it fairly cheaply and it owes me nothing. It has even been reasonably reliable. But it is just scruffy enough (TX truck with...

Engine runs smooth at startup but after it gets to operating temp and goes into closed loop, starts missing and running rough, with "Slow max 35mph" warning displayed. Has p1777 gearbox fault cleared and not recurrent. Has p1316 misfire. Pumped smoke to find vacuum leaks, none present...

Hi , I had a rover given to me for free because my friend could not get it to start and was a project he no longer wanted...I jumped the starter with a screw driver and it started right away .it was blowing smoke like no other and overheated quickly. I took it apart and obviously the headgaskets...

I have a 1996 Range Rover 4.6 HSE and I seem to have some type of limiter at 3000 RPM? When in park or neutral the revs will go to just over 3000 RPM (approx. 3250 RPM) and will jump from there to approx. 2750 RPM. When driving it will go to 3000 and will not allow the engine to exceed that. You...

'99 Range Rover 4.6L Bosch Engine: Coolant stream from area of Rear lifting eye Hello, We replaced the head gaskets on my son's '99 Range Rover 4.6L w/ Bosch engine. After all assembled, started up and seeing a steady pencil-lead thick stream of coolant issuing from below the rear lifting eye...

Well. It's happened to me. Coolant had a pinhole leak which caused an air pocket. Temp only went into the red for a second. Luckily got home from across town after cooling it off and flushing the coolant. Pressure tested the system with the oil pan bolt off, and it was leaking coolant out...

Hi - New here, just got a 4.6 1997 and it started to misfire, I check the coil pack and found Nr8-5 to spark great the rest are low and some times stop working. I swoped pac 8-5 with 7-4 and 8-5 was the sparking like mad bad the rest just strobes the light and bearly shocks.